Pictures 2 Page
BY
site
| Some Pictures of My "Water Fuel" Project |
This page is under construction
Waterworks 4 Fuel . COM
| Electronic Fuel Injection Enhancer E F I E rubber dipped model Basic Single O2 sensor device Purchased from Eagle-Research.com |
| Water Hydrolysis Cells |
| 10-1/2" plates for 14" cell |
| For 8" tall cell 3" x 5" plates |
| 8" cell 3" x 5" plates |
| 10-1/2" plates for 14" cell |
| This is the first design that I built. I had to abandon it because It runs too hot positive - negative with no neutral plates.. [ See the 8" Cell" ] above. |
| Dual Cell with 4 neutral plates each 11 plates total works best. |
| Flashback Arrestor - A Safety Essential This copper or brass pipe is packed with Bronze wool to prevent explosions In the gas Generator |
| Flashback Arrestor 3/8 inch Pipe 4 inch length |
| Packed with Bronze Wool for a fire stop |
All the above Pictures on this page are my own original work,
based on my own experiments, and testing. It is my desire to
make this information available to the public domain. If you would
like to help, Please make a generous donation.
$5.00 - $25.00 - $50.00 - $500.00 - or up to$1 million.
You can send it to suppoprt@jet-usa.com by PAYPAL. I will
gladly share my knowledge with anyone. It is time for all Americans
to benefit from this information.
All this work has costs. If you find this information useful, then
please help support this website.and my affiliates.
based on my own experiments, and testing. It is my desire to
make this information available to the public domain. If you would
like to help, Please make a generous donation.
$5.00 - $25.00 - $50.00 - $500.00 - or up to$1 million.
You can send it to suppoprt@jet-usa.com by PAYPAL. I will
gladly share my knowledge with anyone. It is time for all Americans
to benefit from this information.
All this work has costs. If you find this information useful, then
please help support this website.and my affiliates.
| Water Reservoir Bubbler Tank With Explosion protection cover |
| Flashback Arrestor |
| Water Gas Bubbler |
Supplimental Hydrogen
From Water
From Water
Bubbler Reservoir
| New Pictures December 2008 |
| PWM -&- 30 amp -Remote Meter With Shunt Resistor |
| 30 amp Pulse width modulator for Duty Cycle Control |
| Safety cap |
| This PWM is a good choice Found on EBAY Auctions |
| It Is also available on the Internet Search for the model number. MX 066 *The box was bought separately. and the ribbon cable was added to the control pot on the cover. |
Run your car on water
| Control Panel (Remote) In Car 1. Switch for EFIE Power on. 2. Switch for Cell power relay. 3. Switch for MAP adjuster circuit. 4. Switch for city or Highway mode A or B. 5. 25K ohm controls A and B. Modes. 6. 75 Milli-Volt meter reads 30 amps With Shunt resistor for remote sensing of 30 amp load. (note) White led is used inside the meter for night Illumination. Series resistor of 3300 ohms is used for the led to keep the load on the led to under 5 ma. |
| See the Files page for Detail Drawings |
| See My Drawing on the Map Adjuster On the Files Page Click Here |
| See Fuelsaver-mpg site for info about the E F I E Click Here |
Updated February 28 2009
Shunt Resistor for 30 amp @ 75 mv.
| It Is Recommended that a cpu cooling fan be added to the cover |